SPK Pitless Kits
The flipper series is made of quality stainless steel for years of service.
Merrill SPK Pitless Kits have a variety of features- Complete pitless kits - discharge outlet, internal parts complete with pull pipe, and watertight cap.
- Full diameter access in well with no obstructions and extra large neoprene spud gasketassures watertight seal.
- Corrosion Protection - Painted cast iron elbow and stainless steel adjusting nut.
- Support Plate - Top of unit holds weight to take stress off internal parts
- Ground screw - Included for electrical pump cable.
More Information
- Certified Watertight PITLESS Kits & Caps
Tested and approved by Pitless Adapter Standard PAS-1, PAS-2, PAS-97(2019), ASSE Standard #1093-2019 and Illinois Code. Approved by all stringent state codes. - Positive Mechanical Seal
By simply turning the stainless steel adjusting nut at the top of the well. Positive operation after years of service. - Full Diameter Access to Well
No obstructions inside well that may need to be removed before working on well, common problem to pitless adapters. Simple and fast installation. - Large Spud Gasket Seal
on discharge ell assures watertight seal around hole cut in casing, and separates discharge elbow and casing, to eliminate corrosion that can make removal difficult. Insures seal to inside of casing. - Discharge Hub Clamps Around Casing
with a U-bolt and backstrap, to prevent distortion of plastic casing if overtightened. Protects from installation mistakes. - Use Existing Casing-Plastic or Steel
Low cost, and most of the advantages of pitless units. No restriction on casing material. - 3 Part Kit
Consists of discharge hub, complete internal parts with pull pipe, and watertight cap. - Steel Support Plate Holds Weight
more weight than pitless adapters, and minimizes danger of losing pump or pipe down well. The weight of the pump, pipe, and water is supported by the plate which uses the strength of the entire top of the casing, not just a small part of the side wall like pitless adapters. Safer and holds more weight. - Cable Slot in Steel Support Plate
allows you to install and service pump without a splice in submersible cable. Easier installation. - Ground Screw in Steel Support Plate
provides a simple and easily accessible connection for the electrical ground of the pump cable. Electrical safety. - Simple Disengagement for Service
by simply turning the stainless steel adjusting nut at the top of well. Simple operation of kit. - Water System Easily Drained
by turning the stainless steel adjusting nut at the top of well, so the entire water system outside of well will drain WITHOUT PULLING THE PUMP, impossible with most other pitless kits and pitless adapters. Simple answer to draining pipe. - Seasonal Homes
The perfect answer for a seasonal home, simply turn off the pump and turn the stainless steel nut inside well cap at the top of well to drain the entire water system - not possible from any other company. Extra application to sell kit. - Stainless Steel Elbow Fitting
available for discharge.
All Pitless Kits listed above have passed the Pitless Adapter Standard PAS-1, PAS-2, PAS-97(2019), ASSE Standard #1093-2019 and Illinois code